Battery replacement tutorial for Smart App LCD UPS Series. Please take the following safety precautions. The batteries for this UPS series are hot-swappable, it is not necessary to power down the UPS. DO NOT replace the battery when the UPS is operating in battery mode. Remove jewelry and other metal objects. Use tools with insulated handles. Only use replacement batteries certified by CyberPower Systems.
To start, pull the right front panel to remove it from the UPS. Remove the wire protection cover by loosening the screws. Disconnect the battery connector and loosen the screws on the battery compartment cover. Slowly pull out the battery tray and replace it with a new one. Tighten the screws on the battery compartment cover and reconnect the battery connector. Reinstall wire protection cover by tightening the screws. To reinstall the front panel make sure the right side goes in first and push the left side to secure. Finally, remember to run the battery test and reset the battery replacement date using the PowerPanel power management software or an installed remote management card. WARNING! DO NOT open the batteries. Released electrolyte is harmful to the skin and eyes. DO NOT dispose in fire as it may explode. Follow all local ordinances regarding the proper disposal of batteries.